It's been a while since the last bathroom update so a lot has happened. Let me catch you up.
We removed the tile floor, toilet and tub and discovered that the subfloor had water damage. Then we discovered that the floor wasn't even properly supported for tile to begin with. So out the entire floor went:
The pipe in the wall is the plumbing vent. The towel is covering the toilet drain. The exposed wood beams are the joists above our newly remodeled kitchen. See how thin the plywood subfloor is?
This is where the sink vanity was.
New drain pipes for the toilet so that we can reposition the toilet away from the tub. One of them is backwards though. Whoops.
Another surprise was a joist in the way of moving the toilet over. We don't mess with structural beams so we were extremely lucky that we were able to move it over under the joist.
This is what we used to join pieces of the A.B.S. drain pipe that we cut to size. I like to refer to it as "Weld-On Abs". Wouldn't it be great if such a thing exists?
New position for the toilet. Moved over about a foot to allow room for the new (and wider) bath tub.
What has not been shown are the countless trips to the hardware store, because of all the times we messed up welding the pipes (third try was a charm though!). Certain pieces are hard to find and eventually were found at a large plumbing specialty store nearby.
Also not shown in the photos is how difficult/scary/frustrating working in a bathroom with no floor is.